Celestron CR-150 HD User Manual download pdf (Page 9)

The CR-150 HD • 9

The tripod comes fully assembled with the metal plate, called the tripod head, that

holds the legs together at the top. In addition, the brackets that support the acces-

sory tray are also attached to the tripod.

Stand the tripod upright and pull the tripod legs apart until the leg brace

assembly for the accessory tray is fully extended (see figure 2-2). The tripod

will now stand by itself. To increase the stability, tighten the bolts that hold

the legs to the tripod head (use the appropriate size wrench from the supplied

set). This will help minimize any flexure or wobble of the legs.

Once the tripod is set up, you can adjust the height at which it stands. To do

this:

1. Loosen the knob on the leg clamp so that the tripod leg can be adjusted.

2. Slide the center portion of the tripod leg away from the tripod head until it is at

the desired height.

3. Tighten the knobs on each leg clamp to hold the legs in place.

Setting Up the TripodSetting Up the Tripod

Setting Up the Tripod

Adjusting the TripodAdjusting the Tripod

Adjusting the Tripod

HeightHeight

Height

Figure 2-2

Setting up the tripod requires nothing more than pulling the tripod legs away from the

tripod head. The height at which the tripod stands can be adjusted by sliding the slats

in the center of each leg toward or away from the tripod head.

Assembling the CG-5 Equatorial Mount

Tripod Head

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 58 59

No comments

Celestron CR-150 HD User Manual Page 9